The impact crusher is a crushing equipment used for secondary crushing. With its own characteristics, it has become an important crushing equipment in the sand and gravel industry. As a result, the equipment has a large wear and tear during the use of the equipment, which leads to the phenomenon of stone sticking. Today, Xiaobian will explain to you how to avoid stone sticking in the operation of the impact crusher.

　　In fact, it is very simple to avoid stone stuck. The skill can be described in six words as "* maintenance and skillful operation". Choose a high-* impact crusher. Pure wear is directly proportional to its speed, so it is very important to choose a reasonable linear speed.

Customers can choose to reduce the wear of the blow bar by reducing the line speed by about 30%. In addition, a reasonable linear speed needs to be matched with the appropriate number of plate hammers. Multiple crushing chambers can be used to increase the number of impacts, ensure good finished product particle size and sufficient entry space for materials, and avoid the occurrence of stone stuck.

　　Secondly, increase the wear resistance of the blow bar, improve the utilization rate of the blow bar, and reduce the replacement time of the blow bar. This requires that the wear degree of the blow bar in use can be uniform and *.

　　The impact crusher is suitable for all kinds of medium and hard materials, such as: basalt, diabase, biotite, granite, etc. At the same time, a combined counterattack hammer is also creatively used. Only the worn parts can be replaced, and the equipment can continue to be used. Parts can also be used up and down, which improves the material utilization rate by more than 48%. This series of designs all increase the weight of the impact crusher, indirectly improve the stability of the equipment, and help reduce self-wear.

　　In addition, in the process of using the crushing equipment, good operating habits and regular maintenance can also completely avoid the occurrence of the phenomenon of counterattack and stone breaking. About two weeks after a new machine has been put into operation, a * inspection of the machine is required on a monthly basis. The motor and lubrication of the equipment need to be *ly checked once a week.

　　The inspection content should include the fastening of the fixed parts, the belt drive, the bearing seal, and the electrical switch. Establish a regular maintenance and replacement system according to the maintenance cycle records of major components. When the rotor is running, the gap between the rotor and the impact liner cannot be adjusted.