The crushing chamber of the jaw crusher is composed of two jaw plates, a movable jaw plate and a fixed jaw plate. As the main vulnerable part, the jaw plate of the jaw crusher wears relatively quickly. Usually on a jaw plate, the lower part, especially the lower third part, wears severely, and the upper part wears less.

 The wear of the jaw plate will affect the working efficiency of the jaw crusher. So today we provide 3 small methods to repair the wear problem of the jaw plate, and extend the service life of the wearing parts and the machine.

Three small methods teach you to extend the life of the jaw of a jaw crusher:
1, Sampling inspection of materials
Carry out random inspections on each batch of incoming materials. When it is found that the nature of the materials fluctuates significantly, adjust the main parameters of the crusher such as: clamp angle, eccentric shaft speed, output and motor power, etc., to make them consistent with the incoming materials. Correspondingly, this can not only improve the crushing efficiency of the equipment but also reduce the wear of the jaw plate.

 2, Do a good job of tightening when installing the jaws
Pay attention to the tightening of newly installed jaws, and ensure that the jaws are in smooth contact with the surface of the body (moving and fixed jaws). A layer of lead board, plywood, cement mortar and other materials with better plasticity can be placed between the two surfaces. The assembly requirement for the movable jaw and the fixed jaw is that the tooth crest of one jaw is aligned with the tooth groove of the other jaw, that is, the movable jaw and the fixed jaw are in a basic meshing state.

3, The jaw plate should be made of materials with high hardness to resist extrusion micro-cutting failure; materials with sufficient toughness should be chosen to resist fatigue failure caused by chiseling impact. At the same time, improvements have been made in the structure of the tooth plate to reduce the relative movement of the material and the tooth plate. Since the jaws are usually made up and down symmetrical, the worn jaws at the lower part can be used upside down during minor repairs. The jaw plate of a large jaw crusher is composed of several pieces, which can be used with each other to extend the service life of the jaw plate. The Red Star Jaw Crusher has a newer movable jaw assembly, which makes it more durable. The movable jaw assembly is composed of high-quality cast steel parts and is driven by two large cast steel flywheels. In addition, the heavy eccentric shaft also uses forging blanks. Processing, which makes the jaw crusher has extraordinary reliability.