With the continuous development of science and technology, the cobblestone crusher has also been continuously *. From the ordinary crusher to the current cobblestone crusher technology, it is constantly updated. It is necessary to continuously develop and update so as to better help users in production. As the equipment needs maintenance for a long time, many users don’t know how to proceed when maintaining the equipment. So how to extend the life of the cobblestone crusher after a long time of work? The following are the main points summarized by the editor for everyone.

1, First, the maintenance of the cobblestone crusher is an important task. The regular work of the cobblestone crusher requires timely maintenance. During production, there should be full-time personnel to conduct on-duty inspections. When the newly installed wheels are prone to loosening Frequent inspections must be carried out, and attention must be paid to whether all parts of the machine are working properly.

2, The bearing of the cobblestone crusher bears the full load of the equipment. Lubrication plays a very important role in the life of the bearing. It can directly affect the service life and operation rate of the equipment. Therefore, the lubricating oil must be clean and well sealed. The main oil injection parts of the cobblestone crusher are rotating bearings, movable bearings, sliding planes and all gears. It is also necessary to check the degree of wear of easily worn parts, and pay attention to replacing worn parts at any time. If the bearing oil temperature rises, s and check the cause immediately.

3, The bottom frame of the movable device should be free of dust and other objects to prevent the movable bearing from moving on the bottom frame when the machine encounters unbreakable materials. Also, if the rotating gear is running, if there is an impact sound, s and check immediately. In order to avoid serious accidents.

4, When the cobblestone crusher is in operation, the activated crusher should be idling for a few minutes *, and the base and the protective plate chain can be checked during idling. If there is no abnormality, the feeding work can be carried out. If it is a new equipment, it can be fed after three shifts. And the equipment feeding should be continuous and even. In order to prevent overload, and the width of the entire feeding port should be the same, so that the crusher will wear evenly, and it will not be damaged in one place, and it will also increase the service life of the equipment.