As the main crushing equipment in the sand production line, the sand making machine equipment is also very lossy. Many customers have questions about the wear problem of the sand making machine. The quality problem of the sand making machine is suspected, and some are due to the use of the sand making machine. Caused by improper use in the process. Only by paying attention to the maintenance and maintenance of the sand making machine can the sand making machine be fully functional and prolong the service life of the sand making machine equipment. 

The bearings of the sand making machine equipment are easy to wear, and this part bears * of the load during the operation of the equipment. Therefore, we must use good lubricants at work and keep them clean at all times. If the lubricant is not clean, it will increase the wear between the bearings, the bearings and other parts. In addition, pay attention not to overheat the bearing. Overheating will reduce the operating efficiency of the bearing and affect the normal operation of the equipment. The transmission device of the sand making machine equipment and the V-belt should be adjusted appropriately to ensure that the V-belt is evenly stressed. When driven by dual motors, it should be distributed reasonably and the strength is the same. The maintenance of the transmission gear and the long-term friction and wear between the transmission gears will also affect the life of the machine. Corresponding to the lubricant used to solve the bearing problem is also one of the important items. 

The stability of the traditional sand making machine is not as good as that of the new sand making machine, and the maintenance rate is higher. But the price of traditional sand making machine is relatively cheap. But no matter in terms of product * or cost-effectiveness, more people are willing to choose a new type of sand making machine. It can improve the output better than the traditional sand making machine, and at the same time can reduce the environmental pollution. 

In the process of small sand making machines, various problems will occur, and vibration is also one of the common problems for users. This is also a common phenomenon, because vibration will occur during long hours of work. If it is vibrated for a long time, it will cause screws. One of the reasons for regular inspection and maintenance of small sand making machines is that the parts are loose or even fall off. Hydraulic vibration isolation, hydraulic support The system is a combination of traditional rubber support and hydraulic damping. It can provide large damping in the low frequency range and quickly attenuate the large-value vibration of the engine. It has low dynamic stiffness and energy at medium and high frequencies, effectively reducing the vibration in the cab And noise.

Of course, there is not only a sand making machine on a complete production line, but also many equipment, such as jaw crushers, cone crushers, vibrating screens, conveyors, etc. The selection of these large-scale equipment is based on the solution of the whole process According to actual needs, not all production lines need to be equipped with a new type of sand making machine. If the requirements for the finished product are not high, the production line only needs to be crushed once and twice, and if the requirements for the finished product are higher, it is recommended Choose a new type of sand making machine.