Hydraulic cone crusher is a kind of crushing equipment with relatively * structure. It can be widely used in many areas of crushing operations such as mines, constructions, road repairs, etc. It also has the advantages of large crushing ratio, high operation efficiency, and uniform product particle size. The majority of users like it. Recently, a friend reported that after using the cone crusher for a long time, it was found that the discharge was too slow. Here is a brief introduction to the reason why the discharge of the hydraulic cone crusher is too slow during operation?

 In fact, there are many reasons that cause the hydraulic cone crusher to discharge too slowly. If you want to deal with the too slow discharge, you must find the corresponding reason, so that the problem of material blocking can be handled well.

1.The * common problem of cone crushing and material blocking is that too much material feeds the equipment, which causes the problem of accumulation and even material blocking. This situation will cause the equipment to discharge slowly. When we run the equipment, we must feed the material at a uniform speed, so that this situation can be avoided.

2.The water content of the processed material is too large. If the stone material to be processed has a high moisture content, after entering the hydraulic cone crusher crushing cavity, following the work of the equipment, under the strong kneading action, it is inevitable that there will be adhesion and adhesion, and even blockage, which is *ly reduced. The crushing ability of the equipment to the material, the * composition of the hydraulic cone crusher is slow. 　

3.The feeding amount is too large. In our use of hydraulic cone crusher for material processing, if too much material is put into the crushing cavity and occupying part of the space in the crushing cavity, the crushing space of the material will be reduced, and then the material will be discharged slowly after crushing. 　

4.The size of the discharge port is incorrect. When the size of the discharge outlet of the hydraulic cone crusher is not appropriate, it simply constitutes that the materials that have been crushed and qualified are too late to discharge in time, and then the material accumulation is blocked, which affects the crushing of the stone, and then causes the hydraulic cone crusher to discharge slowly.

5.As a kind of mechanical equipment, hydraulic cone crusher will be accompanied by certain equipment aging after long-term use. At this time, we must carry out regular protection and maintenance methods for the equipment. Check whether there is a problem with the equipment, find the problem in time, deal with the problem, and replace the severely aging accessories, so as to avoid the problem of slow processing.

6. If the water content of the material is high during the crushing, it may cause the material to stick or even block the discharge port after crushing, and then cause the equipment to discharge too slowly.