The cone crusher adopts the laminating crushing principle. The good grain size is a big advantage of the cone crusher, but occasionally there will be uneven discharge. Finding the reason is the * important. The following brief introduction causes this problem. There are several common reasons.

1. The material size is too large and too hard. When there is material with excessive or excessive particle size in the crushing chamber, the particle size of the crushing chamber of the cone crusher will be segregated seriously, and the input material cannot be completely broken, resulting in uneven discharge.

2. The material contains too much water. When the excessively watery material enters the crushing cavity of the cone crusher, it will stick together to cause blockage of the material in the crushing cavity, which reduces the ability of the equipment to break the material, thereby causing uneven discharge.

3. The size of the discharge port is improper. When the size of the discharge port of the cone crusher is not correct, it is easy to cause the material that has been broken to be discharged, which causes the blockage of the material, which affects the crushing of the material, exacerbates the blockage of the material, and causes the material to be broken unevenly.

4. The voltage is too low. When the working voltage at the crushing site is too low, it is impossible to provide production conditions for the normal crushing of the cone crusher, and the crushing power is insufficient to cause uneven particle size of the crushed product.

5. Too much material is fed. When too much material is put into the crushing chamber, the material is easily blocked in the crushing chamber, occupying a part of the space inside the crushing chamber, so that the material crushing space is reduced, and the particle size of the crushed material may be uneven.