Large equipment is inevitably faced with a problem, that is, the failure rate, cone crusher is no exception, the working environment is poor, long working hours will cause cone crusher failure, how to reduce equipment failure is our primary concern, Jiaozuo Zhongxin technical engineer gave you a few tricks.

1. Do a good job of temperature control management. The cone is broken in normal work, and each component has a normal operating temperature range. If the temperature of a component is abnormal, it is likely to cause damage to the relevant component. Especially for bearing parts, etc., if the temperature is too high, it must be carefully checked. Usually, the lubrication is not enough to cause the bearing to burn out.

2, do a good job of dust and dust removal. Due to the special nature of the cone crusher production environment, a large amount of dust and fine particles will inevitably be generated during the working process. If the dust and dust removal faults are not done, the impact on the equipment will be very large. Especially when these dust particles enter the lubrication system, the wear of the equipment itself will be *ly accelerated, and the service life of the crusher equipment will be affected, which will easily cause the failure of the crusher equipment. In response to such problems, we must not only do the dustproof work of mechanical equipment in the daily production work, but also pay attention to the quality when selecting the parts with higher requirements, and also choose the quality as good as possible for the lubricating oil. , varieties with less impurities.

3. Corrosion of corrosive materials should be protected. In the use of the cone crusher, due to its wide range of use, it is easy to damage the broken parts of the crusher when crushing corrosive materials such as acid and alkali. Usually such materials need to be subjected to the relevant acid reduction, alkali reduction treatment or special crusher related components before being crushed. The specific situation needs to be considered according to the corresponding production environment and requirements, as well as the cost of demand input.